Somnetics Transcend Guide De Référence Rapide page 10

CLEANING AND REPLACING THE FILTER MEDIA
The Transcend Filter Media should be replaced every
six months. Contact your homecare dealer to
purchase a replacement Filter Media.
1. Remove the filter frame by gently pressing the
button release and lifting the plate away from the
CPAP (Image 1).
2. Remove the Filter Media from the filter frame
and discard.
3. Insert a new Filter Media into the filter frame
(Image 2).
4. To replace the new filter frame, lay it on the
bottom of the CPAP. Snap the front clips into
place first, then snap the connector into place.
The Filter Media should be removed and cleaned weekly.
1.
To clean the Filter Media, first submerge a lint-free
cotton cloth into the cleaning solution*.
2.
Wring excess water from the cloth.
Gently pat the Filter Media with the cloth.
3.
4.
Dry surfaces by wiping with a dry, lint-free cotton
cloth.
Allow the Filter Media to air dry at room temperature
5.
for approximately 30-60 minutes before
reassembly. Drying time will depend on ambient
conditions.
Reconnect the Filter Media and filter frame to the
6.
Transcend.
TRANSCEND QUICK GUIDE • ENGLISH
1
2
Earlier versions of Transcend may
Note:
require that the complete filter frame be
replaced. Refer to the User Manual supplied
with the device.
* A solution of 5% mild liquid detergent in
distilled water (1.6 fl oz liquid detergent per
quart of distilled water) is recommended.
• PAGE 10