Back Panel - Vonyx ST100 MK2 Manuel D'instructions

BACKPANEL
OPERATION INSTRUCTIONS
External AC
Plug one end of the AC cord provided into the AC input jack (1) on rear side of the amplifier. Then plug the other end of AC cord
into AC power outlet. Turn on the unit using the main power switch.
External DC
This unit can be powered also using external 12V DC power. Connect external 12V DC power to DC input connector on rear
side of the amplifier. Observe the correct polarity!
Rechargeable Battery
This unit can be powered internally using the built-in rechargeable battery. When AC power is connected, CHARGE LED
indicator will light red. The rechargeable battery is being charged. If FULL LED indicator light green, the battery is fully charged
and ready to power the unit alone.
Shut off the power switch and disconnect the AC power. Turn the unit back "ON" and the rechargeable battery will power the
unit alone.
Note: Turning off the unit power switch will allow the battery to be charged more quickly.
ATTENTION:
Before the device the first time is actuated, please charge the battery at least 12 hours and max. 72 hours!
Battery should be regularly charged. For optimal battery life the battery should be charged at least 1x per month.
Please note that if you do not load within 6 weeks, the battery becomes defective !!
Warning!
This device is equipped with a class 1 laser diode. To ensure a safe operation do not remove any covers or
attempt to access the inside of the product. There are no serviceable parts inside the device. Maintenance and
service operations are only to be carried out by authorized dealers.
1. AC Power input 230Volt AC
2. Fan
3. External DC 12V power
4. Fuse
5. RCA line output connector
6. Antenna
5