Weston #8 ELECTRIQUE Serie Mode D'emploi page 4

IMPORTANT SAFEGUARDS
15. Never use fingers to scrape food away from the grinding plate while
the grinder is in operation. Severe injury may result.
16. Never operate the grinder unattended. Be safe. Disconnect the
grinder from power source before leaving the work area.
17. Avoid contacting moving parts. Never feed food by hand. Always
use food Stomper.
18. To reduce the risk of severe personal injury, and/or damage to
the grinder, tie back loose hair and clothing, and roll up long
sleeves before operating the grinder. Remove ties, rings, watches,
bracelets, or other jewelry before operating the grinder.
19. Be sure the grinder is on a stable work surface. Be sure all the
grinder feet are stable.
20. Do not let cord hang over edge of table or counter or touch hot
surfaces, including stove
21. Do not run grinder without meat in the head. Severe damage to the
head and auger may occur.
22. Wear eye protection. Wear safety glasses. Everyday eyeglasses
are not safety glasses. Safety glasses conform to ANSI Z87.1
requirements. NOTE: Approved safety glasses have Z87 printed or
stamped on them.
23. Do not use appliance for other than intended purpose.
24. Do not attempt to operate the grinder if the grinder itself is cold. The
grinder temperature should be at least 45°F (7°C) before beginning.
25. Do not operate the appliance for more than 15 minutes at one time.
After 15 minutes of continuous use, allow a few minutes for the
appliance to rest before next use.
26. Grinding blade is sharp. Handle carefully.
27. Do not place on or near a hot gas or electric burner, or in a heated
oven.
28. CAUTION! In order to avoid a hazard due to inadvertent resetting of
the thermal cut-out, this appliance must not be supplied through an
external switching device, such as a timer, or connected to a circuit
that is regularly switched on and off by the utility.
4
SAVE THESE INSTRUCTIONS