Jet JDP-2800VS Mode D'emploi page 7

9. Trouble shooting
Motor doesn't start
*No electricity-
check mains and fuse.
*Defective switch, motor or cord-
consult an electrician.
Chuck will not stay on spindle
*Oil or grease on contact surfaces-
clean the tapered surfaces of chuck
and spindle.
Machine vibration
*Worn drive belt-
Replace belt.
*Dry spindle quill-
lubricate spindle quill.
*dull drill bit-
resharpen drill bit.
Drill bit burns
*incorrect speed-
reduce speed.
*Chips clogged-
retract drill bit frequently
*dull drill bit-
resharpen drill bit.
*feeding too slow-
feed faster.
Drill leads off
*cutting lips or angle not equal-
resharpen drill bit correctly.
*drilled hole off centre-
drill a pilot hole first.
*bent drill bit-
use a proper drill bit.
*drill bit not properly installed-
install drill bit correctly.
Laser cross not on drill centre
*laser cross not adjusted correct-
adjust laser (see maintenance)
*laser not adjusted vertical-
adjust laser (see maintenance)
Laser doesn't work
*Defective line laser or power supply-
consult an electrician
Repair work on the laser beam may
only be carried out by a specialist.
10. Environmental protection
Protect the environment.
Your appliance contains valuable
materials which can be recovered or
recycled. Please leave it at a
specialized institution.
11. Available accessories
Refer to the JET-Pricelist.
9