Safety And Maintenance; Risk Of Damage; Technical Specifications - SE Electronics V7 X Mode D'emploi

Tips for practical use
Point the microphone directly towards the sound source as much as possible to get a dry, direct
sound and high gain before feedback.
The closer the distance from the microphone to the source, the more bass you'll get ("proximity
effect"). Use this to your advantage when you want it, and be aware of it when you don't.
The fewer microphones you are using on the stage the better. Use just one microphone per source
to minimize to risk feedback.
Make sure the microphone is positioned behind the PA speakers to reduce the risk of feedback.
If several microphones are necessary (e.g. choir miking) apply the 3:1 rule: The distance between
the microphones should be at least three times the distance of each microphone to its source.

Safety and maintenance

Cleaning the microphone
After every use, clean the microphone with a dry, soft cloth tissue and store it in a solid case or a
zipper pouch.

Technical Specifications

Capsule
Voice coil
Magnet
Polar Patterns
Frequency Range
Sensitivity
Electrical Impedance
Recommended Load Impedance
Connectivity
Dimensions
Weight

Risk of damage

Please make sure that the piece of equipment to which your
microphone will be connected fulfils the safety regulations enforced in
your country and is fitted with a ground lead.
Diameter: 47 mm (1.85 in.) Length 176 mm (6.93 in.)
Dynamic
Aluminum
Neodymium
Supercardioid
30 – 19,000 Hz
2.0 mV/Pa (-54 dBV)
300 ohms
>1K Ohms
3-pin male XLR connector
269 g (9.49 oz)
3