Prepare And Adjust Flash Trigger - Walimex Pro VC-300 Excellence Plus Mode D'emploi

3. Switch off audio signal:
Press push-button AUDIO.
• The LED AUDIO goes out.
• After triggering a flash, the modeling lamp
goes out for a while and lights up again,
when the device has reached the adjusted
flash output again.
• A short beep can be heard when reaching
the adjusted flash output.
10.5 Prepare and adjust flash trigger
Prepare flash trigger through camera
NOTE
Please note the user information of the
camera manufacturer for flash synchroni-
sation.
1. Connect sync cord (included in delivery)
with the connecting socket on the device.
2. The other end of the sync cord should be
connected with the PC jack socket of the
camera.
Prepare flash trigger through remote
receiver (optional)
NOTE
Please note the user information of the
remote receiver manufacturer.
Connect the cable of the remote receiver with
the socket for the sync cord.
Switch on and off of flash trigger through
built-in photo cell
The photo cell enables the device to trigger
through:
• another external device
• on-camera flash devices with integrated
pre-flashes
1. Switch on device.
See Switch the device on and off.
2. Switch on photo cell:
Press push-button SLAVE.
The LED SLAVE lights.
3. Switch off photo cell:
Press the SLAVE button, until it goes out.
Flash triggering via the integrated radio
NOTE
Flash settings can only be made if the set-
tings between transmitter and receiver in
the flash unit are matching. The test button
on the transmitter can be actuated at any
time and will trigger a flash.
Pre-flash settings
Setting the time:
1. Press the SLAVE button for about 8 sec.
2. The display shows "t".
3. Use the arrow keys to set the time (up to
5 sec.) until the flash should be triggered.
Display t
Time in seconds
Setting pre-flash suppression
1. Press the SLAVE button for about 4 sec.
2. The display shows "c".
3. Use the arrow keys to adjust the flash for
triggering, e.g. up to the 7th pre-flash.
Setting time based pre-flash suppression
1. Press the SLAVE button for about 8 sec.
2. The display shows "t".
3. Press the SLAVE button 2 times to access
the adjustment "G.." (group).
4. Use the arrow keys to block to block flash
triggering for up to 18 milliseconds.
1 2 3 4 5
1 2 3 4 5
35