Setting Input Signals - Sony LKRI-005 Mode D'emploi

2

Setting Input Signals

1
For details on how to select the desired setting from the SCREEN CONTROL window,
refer to the operating instructions for SRX-series projectors.
2
Left panel
INTER LOCK ETHERNET RS232C
To DVI-D connector
DVI cable (not supplied)
To DVI output connector
Input signals.
Select the input signal you want to project on the screen from this
board using the "Input signal select drop-down list box" in the
SCREEN CONTROL window.
According to the input signal type, set "Signal Mode" on "Input
Source" in the PICTURE CONTROL window of the SRX
Controller.
DVI-D AUX
To AUX connector
Computer
25
Installation