Additional Error Messages; Specifications - Sony LKRI-005 Mode D'emploi

S101
Switch 1
ON
OFF
ON
OFF

Additional Error Messages

No. Error message
41 DVI SIGNAL FAILURE

Specifications

20
Operation
• Turn the projector off before changing the setting of the DIP switches
(S101, S102).
When you connect a computer to the DVI-D connector or the AUX
connector, set the desired EDID ROM. EDID ROM to be used vary
depending on the input signal type.
For details, see "Setting the DIP Switches (S101, S102)" (page 22).
For both the Switch 1 and Switch 2 of S101, the same setting is required.
Switch 2
ON
OFF
ON
OFF
When you install this board into a projector, the following error
message will be added.
For details on error messages, refer to the operating instructions for SRX-series
projectors.
Meaning
An inappropriate menu setting or input signal is
found, or the cable is disconnected or down.
Input
Quantization
Dimensions (w/h/d)
Mass
Supplied accessory
S102 EDID ROM used
OFF ROM1
OFF ROM2
ON ROM3 (factory setting)
ON ROM4
DVI 24-pin, male (2)
DVI-D, AUX:
DVI1.0 (When 8 bits are set)
8 bits (DVI1.0)
10 bits (Sony unique specification. When the
Single mode or Twin mode is set)
168 × 26 × 200 mm (6
Approx. 300 g (11 oz)
Operating Instructions (1)
5 × 1 1 × 7 7
/ / / inches)
8 16 8