Table Des Matières; One Machine Used To Pull; Cable Around Pulleys - Hog Slat Grower Select HS583E Mode D'emploi

Ventilation Systems
7. Cables should exit 90 Degrees to cabinet side to ensure even load on both sides of load block.
Changing the exit angle will change force distribution on load block resulting in shorter load
nut life.
Figure 3
Figure 5
8. Install corner brackets, through wall brackets and hand winch. Use bearing supported pulleys on
any pulley that rotates during operation of machine. Following figures show examples of
external cabling and hand winch location.
Hog Slat Inc. Newton Grove, NC USA May 2019
Figure 4
One machine used to pull two
curtains from both sides, loop

cable around pulleys.

(Figure 3)
One machine used to pull
curtain from LEFT side, loop
cable around pulleys.
(Figure 4)

One machine used to pull

curtain from RIGHT side, loop
cable around pulleys.
(Figure 5)
REV A10
8