(Figure 3) - Hog Slat Grower Select HS583E Mode D'emploi

Ventilation Systems
4. DO NOT OPERATE MACHINE while hanging on this bolt. Level machine and secure machine
using 3/8" x 2" Lag bolts (supplied) in the (6) mounting locations. (Figure 2)
(4) Inside
chassis
mounting
locations
5. When connecting cables, the load nut should be near the "Closed" position to allow enough
cable for manual winch connection.
6. Run cable ends through side of machine around pulley down to the load block. Route cables
around pulleys as shown in figures 3,4 and 5 that best suits the application.
Hog Slat Inc. Newton Grove, NC USA May 2019
(2) External
Mounting
Locations
Figure 2
REV A10
Vertical mount and outdoor installations,
DO NOT REMOVE PLUGS IN TOP OF
MACHINE
If mounting does not allow the use
of these locations, install 3/8" to
1/2" diameter bolts with nuts in the
holes to secure internal thrust plate
to machine cabinet. Failure to
secure the thrust plate could result
in plate damage during heavy-load
conditions.
7