Operation; Functions - Zibro D2010 Manuel D'utilisation

DISPOSING OF THE APPLIANCE
The appliance contains a certain amount of coolants, and when the appliance is going to be scrapped, it
should be taken to the local recycling station which can dispose of such materials.

3. OPERATION

PLEASE READ THIS CAREFULLY BEFORE CONNECTING THE
UNIT!
Transportable dehumidifiers are ideal for the home and office. They improve the indoor climate, leading to a
healthy environment. Dehumidifiers prevent mould and fungus while keeping the relative air humidity low,
which ensures unfavourable conditions for dust mites.
GENERAL INFORMATION ON DEHUMIDIFIERS:
You may only see water in the water tank after approximately 8 days of using the dehumidifier for the
following reasons:
•
after transportation, the fuel in the dehumidifier needs time to 'settle'.
• the built-in hygrostat needs time to determine the relative humidity of the room.
•
there is a pipe linked to the permanent drain that must be filled up with water (happens automatically)
before the water begins to drip down into the water tank.
The air dehumidifier is suitable for dehumidifying a room of up to 75m². However, this depends on the
ambient temperature and the relative humidity. The effect of the air dehumidifier is higher at a combination
of high temperature and high air humidity.
A relative humidity of around 50% and below is recommended for living areas.

FUNCTIONS

The appliance can run in either "Stand-Alone Mode", where all humidity is removed from the surrounding air
and collected in the built-in water tank in the appliance, or "Continuous Draining Mode", where the water is
removed from the air and led to an external drain via the built-in outflow using the attached plastic hose.
STAND-ALONE MODE
Here, the rubber plug is placed in the outlet pipe on the back of the appliance, and all humidity is removed
from the air and collected in the built-in water tank.
When the tank is full, the light on the control panel comes on,
emits a short beep to show that the water tank is full. Once this happens, the water tank must be removed
and emptied. When the empty tank is replaced, the dehumidifier starts again automatically.
CONTINUOUS DRAINING MODE
Here, the rubber plug is removed from the outflow pipe on the back of the appliance and one end of the
accompanying transparent, flexible plastic pipe is pushed over the outflow pipe. (The rubber plug can be
pushed over the protruding tap above the outflow pipe to avoid it getting lost).
The other end of the plastic pipe is led downwards to a place where the humidity can drain away
continuously.
As a result, water does not collect in the built-in tank, and the visual and acoustic signals indicating that the
built-in water tank is full do not function. The appliance runs continuously when used in this manner.
FULL WATER TANK
Using the "Stand-Alone" function, humidity is removed from the air and collected in the built-in water tank.
When the tank is full, the light on the control panel comes on, the appliance switches off and also emits a
short beep to show that the water tank is full. When this happens, the water tank must be removed and
ZIBRO D 2010
the appliance switches off and also
34