Aiwa LED-251FHD Mode D'emploi page 5

8
en
DISASSEMBLY AND INSTALLATION
WALL-HANGING BRACKET
An optional wall mount can be used with
your television.
Consult with your local dealer to purchase
the recommended wall mount.
Carefully attach the wall mount bracket
at the rear of the TV.
Install the wall mount bracket on a solid
wall perpendicular to the floor.
lf you are attaching the TV to other
building materiaIs, please contact qualified
personnel to install the wall mount.
Detailed instructions will be included
with the wall mount.
Please use a wall mount bracket where
the apparatus is adequately secured
to the wall with enough space to allow
connectivity to external devices.
- Disconnect the power before moving
or installing the TV. Otherwise, electric
shock may occur.
- Remove the stand before installing the TV
on a wall mount by performing the
stand attachment in reverse.
- lf you install the TV on a ceiling or
slanted wall, it may fall and result in
severe injury. Use an authorized wall
mount and contact the local dealer or
qualified personnel. Otherwise it is not
covered by the warranty.
- Do not over tighten the screws as this
may cause damage to the TV and void
your warranty.
- To prevent injury, this apparatus must
must be securely attached to the
floor/wall in accordance with the
installation instructions.
- Use the standard M6*12mm screws
and wall mounts that meet the
following specifications.
Any damages or injuries by misuse or
using an improper accessory are not
covered by the warranty.
Notes:
1. For the TV sets with terminals towards
the wall, in order to leave enough space
to use the terminals, a rubber cushion is
needed with each screw to fix the wall
mount.
lt is small hollow pillar whose internal
diameter is 8mm, external diameter is
18mm and height is _ > 15mm.
2. The information in this document is subject
to change without notice. The manufacturer
accepts no liability for damage resulting directly
or indirectly from faults, incompleteness or
discrepancies between user manual and the
product described.
In a dry environment due to static
3.
electricity, the product may restart and
return to the main OSO interface, USB
player interface or the previous source
mode. lt is normal and please continue to
operate the TV as you normally would.
DESCRIPTION OF THE TELEVISION
FRONT VIEW
LED DISPLAY SCREEN
IR REMOTE CONTROL SENSOR &
POWER INDICATOR
In standby mode the indicator light
is red; when switching on the TV the
indicator light turns blue.
STAND HOLDER
SIDE VIEW
VOL+ VOL-
CH+ CH-
MENU SOURCE
VOL+ VOL-
CH+ CH-
MENU SOURCE
9
POWER
POWER
VOL+ / VOL- (VOLUME +/-)
Press left to increase or right to decrease
the volume level.
CH+ / CH- (CHANNEL +/-)
Press left to select the next or right to
select the previous channel.
MENU
Access settings menu.
SOURCE
To select the input source.
POWER BUTTON
Turn the TV on or to standby mode.