RIKTA ESMIL 1A Mode D'emploi page 35

RIKTA – ESMIL (1A)
® ®
II.
Set the device aperture [9] to the specified
zone of treatment.
III.
Press the
Short double beep will sound:
treatment impact on the zone begins.
During the treatment procedure, time LED
indicators [3] will blink and indicate the time
remaining until the end of the exposure:
– more than 2 minutes left — «5 min» indicator blinks;
– 1–2 minutes left — «2 min» indicator blinks;
– less than 1 minute left — «1 min» indicator blinks.
On expiry of the set time, a triple "beep" will sound: the treatment of the zone
is finished.
Proceed to the next exposure zone according to the Methodical manual.
You can stop treatment at any time by pressing
If you press this button again, the treatment will start again at the
previously set frequency and time values.
button.
35
button.
EN