asmodus LUSTRO Manuel D'utilisation page 75

Using the Device
73
Change between Swipe and Click Control of Touch Screen: Press and hold the
PADLOCK symbol to select, weather you want to control the touch screen via swipe or
click mode by pressing " " or " ". Press the Fire button to confirm your setting and end
the process.
Standby Mode: Press and hold the STOPWATCH symbol to define, after which time the
screen will change to standby mode by pressing " " or " ". Press the Fire button to confirm
your setting and end the process.
Checking / Setting Resistance: Press and hold the OHM symbol to check or set the
resistance of the head. The display will show the resistance as automatically read by the
device. To change the resistance value, tap "ADJ". Then press " " or " " to set the desired
value. Press the Fire button to confirm your setting and end the process.
Note: Make sure that the evaporator head is cold before confirming or setting the resistance value. Otherwise, the
device may not work, or at least improperly.