General Operation - Irritrol R-100-KIT Mode D'emploi

General Operation

To Power the Remote Transmitter:
1. Press the red MODE/PWR
2. Press and hold MODE/PWR
Note: Turning off the transmitter does not turn off a station in operation. (See Stop All Watering to stop an active station.)
Automatic Power Down of Transmitter
To extend battery life, five minutes of button inactivity will shut off the transmitter.
To Set the Number of Stations:
To save time using the remote, set the number of stations in the transmitter to match the number of stations on the con-
troller. For example, for a 12-station controller, set the transmitter to a station maximum of twelve also. If only using 8 of the
12, set max to 8.
1. Press the SETUP
2. Press either the UP
3. With the desired number displayed, press ENTER
To Start Program "A" or "B" or "C" (not functional in all controllers):
1. In manual station mode, press the UP
button again for "P-B" or again for "P- C".
2. With the desired Program displayed, press ENTER
Note: The "Manual Program" feature does not work with MC-E controllers.
A remotely started program runs continuously.
button to turn on.
button (about two seconds) to turn off.
button once to view the Max Station screen.
or the DOWN arrow buttons to set the desired maximum station number.
arrow button to go beyond the highest station. "P-A" appears. Press the UP
.
for a sequential station run.
9