Introduction To Programming - Chamberlain LiftMaster K001D8075-1 Manuel D'installation

PROGRAMMING

INTRODUCTION TO PROGRAMMING

Many programmable functions require that a LiftMaster
Entrapment Protection (LMEP) device be installed in order to
function. Refer to the Entrapment Protection section.
Before programming the logic board, set the operator's open and
close limits. LEDs on the logic board are provided to assist setting
the limits. As each limit is activated the corresponding LED will
light up. The abbreviations are Open Limit Switch (OLS), Close
Limit Switch (CLS) and Sensing Limit Switch (SLS). Refer to the
installation manual for limit switch adjustment instructions.
When power is applied to the operator, the following LED's will
illuminate: STOP, CLOSE, OPEN, LMEP, 24Vac, RADIO, DATA,
TIMER ENABLE, OLS MID, SLS, CLS, and MAS. Once the power
up process is completed (approximately 2-3 seconds) only the
appropriate LED's will continue to be lit (i.e., STOP, 24Vdc, limit
LED(s) if limit(s) is activated).
NOTE: When the power up process is over, the MAS LED will blink
a code indicating the version of fi rmware. If the selector dial is in
the DIAG, OPTN, or PROG position, the MAS will not provide this
code. After the code has been provided the MAS LED will go out.
LOGIC BOARD OVERVIEW
Optional Auxiliary
Card Receptacles
Motor Direction Jumper
Maximum Run
Radio Learn Button
Mid Stop Learn Button
Timer-To-Close
Timer Button
Learn Button
Selector Dial
(used for programming
and selecting wiring type)
LOGIC BOARD PUSH BUTTONS (OPEN, CLOSE, STOP)
Open, Close and Stop buttons are mounted directly on the logic
board. Thus, making it easy to program as well as have door
control at the electrical box.
Either the stop control or a jumper MUST be wired between
terminals 4 and 5 for the on board push buttons to function.
24VAC
POWER
24VAC
TIMER
DEFEAT
OLS
COMMON
MID
MAS
SLS
CLS
LMEP:
MRT MID TTC TIMER
EDGE:
ENABLE
OPEN
RADIO 1 2 3
CLOSE
STOP
T TS
E2
FSTS
COMMON
D1
DIAG
C2
OPTN
PROG
B2
SBC
RELAY A
RELAY B
Main Motor Control Harness Connection
2
DATA
14
Single Phase &
Three Phase Jumper
13
12
Maintenance Alert
System Button for
11
Programming
10
9
Open Button
8
Close Button
7
Stop Button
6
5
4
Control Wiring
3
Terminal Block
2
1