Getting Started - Seko TWINDOSE 20 Manuel D'installation

1
1.1
Get ready for a whole new experience. TWINDOSE 20 has a fresh, new look and it's easier than
ever to use.
GETTING
STARTED
The TWINDOSE 20 dispenser was designed to dispense warewashing chemicals to door and
conveyor-type warewashing machines by using an advanced technology to meter precise
amounts of product to the warewasher. Independent electronic circuit boards control all injection
Installation
of products that are delivered to the wash tank via peristaltic pump. Injection control is set with
DIP switches.
This book explains how to get TWINDOSE 20 set up and where to turn for help, so you can enjoy
Set Up &
the most intuitive dosing system yet.
Operation

Maintenance &
precautions. Always follow good safety procedures, including the use of proper clothing,
Accessories
eye and face protection.

Troubleshooting
Contacting SEKO
1.2
Before you start, check that your box contains the following items:
 System enclosure with entire peristaltic pump on board;
 Foot filter (2);
 Detergent Injector (1)
 Non Return Injection Valve (Rinse) (1);
 2-wire cable, 2x1.5 type H-05 VVF 3mt.

Inlet and outlet tubing

Jumpers (2)
1.3
 Power Supply: 24 115-230 Vac 50/60 Hz
 Power Consumption: 8 W
 Detergent Pump Flow rate: 1 ... 6 l/h
 Rinse Pump Flow rate: 0. 18 ... 1 l/h at 3 bar
 Protection of the System: IP65. The gasketed enclosure on the TWINDOSE 20 is highly water
resistant and the electronics are further protected within the enclosure
 Weight: 3 kg
 Dimensions: L 195 P 110 H 168 mm
TWINDOSE 20

GETTING STARTED

WELCOME
Please review this manual carefully. Pay particular attention to warnings and
Please be sure to read entire manual and select operating mode before installation.
WAT'S IN THE BOX
FEATURES
Rev. 1.4 cod. 0000136325 2