Silhouette DIM32D1BSSPR Guide D'utilisation Et Soins De Propriètaire page 9

This machine is intended to produce ice only. It is not intended for the
long-term storage of ice. Move any excess ice into a freezer for long-term
storage (>6 hours) if you desire to keep it.
CHANGING THE SIZE OF ICE
NOTE: Ice cube sizes differ by density and not volume. A large cube is the same size as a small cube but contains
more frozen water.
1. Ensure the water supply is connected before changing ice size. The ice maker is automatically set to make
medium ice. If you need to change the ice size, you can press the corresponding buttons (see previous page) and
the chosen ice size will be indicated by the corresponding indicator light.
2. If you want to stop making ice but keep the unit on standby, press the power button for about 3 seconds. All ice
indicator lights will turn off and the power indicator light will continue fl ashing. You are now in standby mode. Do
not leave the unit in standby mode in excess of 6 hours. If you want to start making ice again, press the power
button one more time.
CONTINUOUS WATER CIRCULATION
This unit operates using a continuous closed cycle of
water, with little or no waste. When the unit is on and the water container is low, new water is allowed in from the water
source. The water container fi lls up until the fl oat on the water tank is triggered. The recirculation pump cycles water
over the evaporator tray continuously until ice is produced. This process is continuous as long as the unit is left on.
Any water that enters the drain at the bottom of the ice maker cavity is not recycled. It goes into a separate receptacle
with a separate drain system that drains out of the back of the unit. This ensures that you're always using clean water.
Note: If the unit is turned off for 24 hours or longer, drain the water from the recirculation system. (see below)
Note: If you are using the continuous drain option (see separate installation instructions) the unit may be turned off
during the draining process. If you are using the drain pump option (see separate installation instructions), you must
keep the unit turned on.
To drain the water from the system: First turn off the water supply. Remove the ice bucket, and pull the rubber
drain tube out from its clips at the front of the internal water reservoir. Slowly lower the rubber drain tube towards the
drain port at the back right side of the ice maker cavity. The water will evacuate. When all the water has been drained,
replace the tube. Note: If using the continuous drain option (see separate installation instructions) and the unit
had been turned off, it may now be turned on again.
ICE BUCKET
Your ice bucket is designed to be easily removed. To remove it, tilt up the front part of the box then simply pull it out
(see Fig. F)
OPERATING INSTRUCTIONS
IMPORTANT
Fig. F
5