Sunbeam CR1001-005 Instructions D'utilisation page 6

setting the time:
1) Use the TIME SET buttons (14) on the back of the unit to set the hour and minutes. Be sure to note whether the correct
AM or PM indicator light is on.
Playing the Radio:
1) Slide the MUSIC SELECTOR switch (3) to the "Radio" position.
2) Adjust the VOLUME CONTROL DIAL (7) to your listening pleasure.
3) Rotate the RADIO TUNING DIAL (6) while watching the RADIO FREQUENCY INDICATOR (2).
4) Slide the MUSIC SELECTOR switch (3) to the "Off" position when you are finished listening.
setting the alarm:
1) Press and hold the ALARM TIME button (9); the time shown on the clock display is the alarm time.
2) While holding down the ALARM TIME button (9), press the HR and MIN buttons to set the desired alarm time. Make sure
the correct AM or PM indicator is lit, ensuring an accurate wake-up time.
3) If you desire to be awakened by the radio, adjust the VOLUME CONTROL DIAL (7) to your listening pleasure before setting
the alarm, as outlined in the "Playing the Radio" section. Slide the ALARM SOUND SELECTOR switch (8) to the "Radio"
position. If you prefer to be awakened by a buzzer, simply slide the ALARM SOUND SELECTOR switch (8) to the "Buzzer"
position.
snooze Control:
When the alarm sounds, a blinking light will illiuminate the snooze button. Simply touch the SNOOZE button (1) to silence the
alarm temporarily. The alarm will sound again approximately 9 minutes later. To permanently silence the "Alarm Radio" or
"Buzzer", press the ALARM ON/OFF button (10).
brightness:
To adjust the brightness level of the clock display, simply slide the DISPLAY BRIGHTNESS SWITCH (5) to either the "Lo" or
"Hi" position.
auxiliary Wire and Plug:
To play music from an MP3 player, mobile phone or other device through the clock radio, a wire with a 3.5mm plug, called
the AUX AUDIO JACK (4) has been provided. Set the MP3 player or audio device next to the clock radio and insert the AUX
AUDIO JACK into the headphone jack of the device. Slide the MUSIC SELECTOR switch (3) to the "AUX" position. You may
now play music from your MP3 player through the clock radio speakers. Use the VOLUME CONTROL DIAL (7) on the clock
radio to adjust volume to your listening pleasure. To disconnect, remove the AUX AUDIO JACK (4) from the MP3 player or
audio device and insert the wire into the AUX AUDIO JACK STORAGE port (13) located on the back of the unit.
6