Controls - NEC MultiSync LCD2060NX Mode D'emploi

Controls

OSM ® (On-Screen Manager) control buttons on the front of the
monitor function as follows:
To access OSM menu, press any of the control buttons ( <, >, –, +, EXIT).
To change signal input, press the SELECT button.
NOTE: OSM must be closed in order to change signal input.
EXIT
< >
/
–/+
SELECT
RESET
NOTE: When RESET is pressed in the main and sub-menu, a warning window will appear
allowing you to cancel the RESET function by pressing the EXIT button.
Brightness/Contrast Controls
BRIGHTNESS
Adjusts the overall image and background screen brightness.
CONTRAST
Adjusts the image brightness in relation to the background.
AUTO (Analog input only)
AUTO
Adjusts the image displayed for non-standard video inputs.
Auto Adjust
Automatically adjusts the Image Position and H. Size settings and Fine settings.
Image Controls
LEFT / RIGHT
Controls Horizontal Image Position within the display area of the LCD.
DOWN / UP
Controls Vertical Image Position within the display area of the LCD.
H.SIZE
Adjusts the horizontal size by increasing or decreasing this setting.
FINE
Improves focus, clarity and image stability by increasing or decreasing this setting.
AccuColor
®
Six color presets select the desired color setting (sRGB and NATIVE color presets are
standard and cannot be changed). R,G,B: Increases or decreases Red, Green or
Blue color depending upon which is selected. The change in color will appear on
screen and the direction (increase or decrease) will be shown by the bars. NATIVE:
Original color presented by the LCD panel that is unadjustable. sRGB: sRGB mode
dramatically improves the color fidelity in the desktop environment by a single
standard RGB color space. With this color supported environment, the operator
could easily and confidently communicate color without further color management
overhead in the most common situations.
LCD2060NXManual021104.p65
Menu
Exits the OSM controls.
Exits to the OSM main menu.
Moves the highlighted area left/right to select control menus.
Moves the highlighted area up/down to select one of the controls.
Moves the bar left/right to increase or decrease the adjustment.
Active Auto Adjust function. Enter the OSM controls. Enter the OSM sub menu.
Resets the highlighted control menu to the factory setting.
(Analog input only)
(Analog input only)
Control Systems
8
8 2/11/04, 7:40 AM