Velleman HQ Power CLLS02B Notice D'emploi page 5

Protect this device from shocks and abuse. Avoid brute
force when operating the device.
Refer to the Velleman® Service and Quality Warranty on
the last pages of this manual.
•
Familiarise yourself with the functions of the device before
actually using it.
•
All modifications of the device are forbidden for safety
reasons. Damage caused by user modifications to the device
is not covered by the warranty
•
Only use the device for its intended purpose. Using the device
in an unauthorised way will void the warranty.
•
Damage caused by disregard of certain guidelines in this
manual is not covered by the warranty and the dealer will not
accept responsibility for any ensuing defects or problems.
4. Use
Refer to the illustrations on page 3 of this manual.
•
Choose an appropriate location to mount the LED-strips.
Note that they can only be used indoors. Do not mount in
rooms with high humidity or on conductive surfaces (e.g.
metal cabinets).
•
[1] Per LED-strip [A], screw 2 mounting brackets [C] onto
the surface. Alternatively, the included double sided tape
can be used to attach the strips to the surface.
•
[2] The LED-strips [A] can be connected to each other
either directly to form a straight line or by using an
interconnection cable [D].
Always place a protective cap [B] on the last LED-strip of
the circuit.
•
Make sure no power is present on the power supply [F]
and connect the LED-strips to it using a power cable [E].
Note that it is also possible to connect each LED-strip
directly to the power supply [F].
•
Plug the power supply into a mains outlet. Note that the
LED-strips are not suitable for use with dimmers or
electronic switches (e.g. motion detectors).
30.07.2009
CLLS02B - CLLS02WW
5 ©Velleman nv