US Blaster USB 7127 Mode D'emploi page 12

USB 7127-7128
Professional Power Amplifiers
The following instructions describe the most common ways to install your amplifier into a sound system.
1. Turn off the amplifier power switch before making any connections.
2. These amplifiers
mono). Re fer to the following wiring diagrams for the speaker connections you wish to make.
(Note: Aolong Systems assumes no liability for damaged speakers resulting from improper wiring, care-
less amplifier use, or over powering.)
• Stereo (Two-Channel) Mode
To put the amplifier into stereo mode, first turn the amplifier off, then slide the MODE SELECTOR
SWITCH (16) to the middle "STEREO" position, and properly connect the input/output wiring as shown.
(Note: Do not connect a speaker load less than 4 ohms as it can damage your amplifier.)
© US Blaster Europe BV
maybe operated in one of three modes (stereo, bridged-mono, and parallel