General Information - Philips SBCHC210/00 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 10
XP SBC HC 210.1 SRS 07-04-2003 10:22 Pagina 4
Introduction
Congratulations!
You have just bought the most
sophisticated InfraRed (IR) cordless stereo
sound system.This system uses the latest
IR cordless technology, which gives you
freedom of movement* while enjoying your
favorite music and movies.Without the
inconvenience of cables or headphone
wires! To ensure you get the best
performance from your IR cordless stereo
sound system please read this manual
carefully.
*) 7 m. max. range, depending on ambient
conditions and restricted to line of sight
with relation to the transmitter.
IMPORTANT
Read these instructions.All the safety
and operating instructions should be
read before using the wireless
headphone system.
Check if the voltage indicated on the
type plate of the adapter corresponds
to the local mains voltage before
connecting to the mains power supply.
Remove the batteries from the
headphone's battery compartment and
disconnect the adapter from the mains
if the system is not in use for a long
period of time.
Prevent fire or shock hazard: do not
expose this equipment to humidity,
rain, sand or excessive heat caused by
heating equipment or direct sunlight.
IMPORTANT
Before using the IR headphone for the
first time, please ensure that the
batteries are fully charged for about
16 hours.This will guarantee a longer
operating lifetime of the batteries.
4

General information

Benefits of Philips latest
IR cordless technology
Cordless transmission
The IR transmitter transmits the stereo audio
signal from your audio or video source to
your IR headphone without wires.
Wide transmission range
Your IR headphone can receive signals up
to a maximum of 7 meters away.
The headphone however needs to be
within the line of sight of the transmitter.
The transmitter should be positioned
slightly lower than the headphone to ensure
best performance: please refer to figure 6.
Easy transmission
High frequency IR waves carry the audio
signal to ensure clear and sharp reception.
Multiple headphones with one
transmitter
An additional number of headphones can
be used with a single transmitter if they
operate on the same frequency.
Please consult the appliance's electrical
specification sheets for confirmation on
compatibility.
Rechargeable system
The IR transmitter recharges the
headphone's rechargeable R03/AAA NiMH
batteries. First switch off the headphone.
Then connect the charging cable between
the headphone and the transmitter.The
green LED on the headphone will light up
during charging. Only use Philips SBC
HB550S batteries.

Publicité

Table des Matières
loading

Table des Matières