Noise Emission; Machine Description; Transport And Installation - Jet Tools GHD-27 Mode D'emploi

GHD-27:
Drilling capacity
Tapping capacity
Spindle to column
Spindle nose to table
Spindle nose to base
Spindle taper
Spindle travel
Spindle speeds...8 75-3150rpm L/R
Column diameter
Table size
T-slots...2
Coolant tank volume
Coolant pump
Overall 750 x 600 x 1800mm
Net weight
Mains 400V ~3L/PE 50Hz
Output power 1,5 kW (2 HP) S1
Reference current
Extension cord (H07RN-F):
Installation fuse protection
GHD-27PF:
Power feed mechanism
0,08 / 0,12 / 0,16/ 0,22 mm/rev

4.2 Noise emission

Acoustic pressure level
(according to EN ISO 11202):
Idling at maximum speed
LpA 76,2 dB(A)
The specified values are emission
levels and are not necessarily to be
seen as safe operating levels.
As workplace conditions vary, this
information is intended to allow the
user to make a better estimation of the
hazards and risks involved only.
4.3 Content of delivery
16mm keyless drill chuck
Arbour B16/MT3
Chuck guard with limit switch
3 Down feed handles
Table rising crank handle
Coolant facility (GHD-27, GHD-27PF
only)
Operating tools
Operating manual
Spare parts list.

4.4 Machine Description

32mm
M20
350mm
max 950mm
1300mm
MT3
150mm
120mm
405 x 505mm
16mm
8 Liter
53W
270 kg
3,2 A
4x1,5²
16A
A....Transport eye bolts
B.....Downfeed handles
C...Table up/down crank
D....Coolant tank (GHD-27 only)
E....Machine table
F....Chuck guard
G....Drill depth stop adjustment knob
H....Control box
I......Speed select levers
J....Emergency stop button
K....Tool eject ON/OFF lever
L....Fw/Rev switch
M....Stop button
N....ON-button
O....Coolant ON/OFF switch
Fig 1
Fig 2
5
5. Transport and start up

5.1 Transport and installation

The machine will be delivered in a
closed crate.
For transport use a forklift or hand
trolley. Make sure the machine does
not tip or fall off during transport.
The machine is designed to operate in
closed rooms and must be bolted to
the floor.
For packing reasons the machine is
not completely assembled.
5.2 Assembly
If you notice transport damage while
unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with
petroleum, diesel oil or a mild solvent.
Screw rubber handles onto quill down
feed handle rods (B). Screw handle
rods into hub and tighten.
Install Table crank handle.
Mounting machine to the floor:
Unbolt the machine from the shipping
crate.
Use heavy duty fibre belt and pass
through the 2 eye-bolts (A) for lifting
the machine off the pallet.
Caution:
The machine is heavy!
GHD-22
GHD-27, GHD-27PF
Assure the sufficient load capacity
and proper condition of your lifting
devices.
Never step underneath suspended
loads.
Carefully place the machine to the
floor.
Use 4 anchor bolts of sufficient size
and length.
230kg
270kg