Table des Matières
Publicité
•
Move throttle control to "FAST" position for deep tilling.
To cultivate, throttle control can be set at any desired
speed, depending on how fast or slow you wish to
cultivate.
IMPORTANT:
ALWAYS RELEASE DRIVE CONTROL
BAR BEFORE MOVING SHIFT LEVER INTO ANOTHER
POSITION.
NUT "B"
OUTER
NUT "A"
SIDE SHIELD
TURNING
•
Release the drive control bar.
•
Move throttle control to "SLOW" position.
•
Place shift lever indicator in "F" (forward) position. Tines
will not turn.
•
Lift handle to raise tines out of ground.
•
Swing the handle in the opposite direction you wish
to turn, being careful to keep feet and legs away from
tines.
•
When you have completed your turn-around, release
the drive control bar and lower handle. Place shift
lever in till position and move throttle control to de sired
speed. To begin tilling, hold drive control bar against
the handle.
OUTER SIDE SHIELDS (See Fig. 11)
The back edges of the outer side shields are slotted so
that the shields can be raised for deep tilling and low ered
for shal low tilling to protect small plants from being buried.
Loosen nut "A" in slot and nut "B". Move shield to desired
position (both sides). Retighten nuts.
TO TRANSPORT
CAUTION: Before lifting or trans port ing,
allow tiller engine and muffler to cool.
Disconnect spark plug wire.
gasoline from fuel tank.
AROUND THE YARD
•
Release the depth stake pin. Move the depth stake
down to the top hole for transporting the tiller. Place
depth stake pin in hole of depth stake to lock in posi-
tion. This prevents tines from scuffing the ground.
OPERATION
DEPTH STAKE PIN
"RELEASED" POSITION
"LOCKED"
POSITION
FIG. 11
Drain
•
Place shift lever indicator in "F" (forward) position for
transporting.
•
Hold the drive control bar against the handle to start
tiller movement. Tines will not turn.
•
Move throttle control to desired speed.
AROUND TOWN
•
Disconnect spark plug wire.
•
Drain fuel tank.
•
Transport in upright position to prevent oil leakage.
BEFORE STARTING ENGINE
IMPORTANT: BE VERY CAREFUL NOT TO ALLOW DIRT TO
ENTER THE ENGINE WHEN CHECKING OR ADDING OIL
OR FUEL. USE CLEAN OIL AND FUEL AND STORE IN AP-
PROVED, CLEAN, COVERED CON TAIN ERS. USE CLEAN
FILL FUNNELS.
FILL ENGINE WITH OIL (See Fig. 12)
1. Remove hangtag from engine.
2. With engine level, remove engine oil fill er plug.
3. Fill engine with oil to point of over flow ing. For ap proxi-
mate ca pac i ty see "PROD UCT SPEC I FI CA TIONS" on
page 4 of this manual. All oil must meet A.P .I. Service
Classification SG-SL.
4. Tilt tiller back on its wheels and then re-level.
5. With engine level, refill to point of over flow ing if nec-
es sary. Re place oil filler plug.
•
For cold weather operation you should change oil for
easier starting (See "OIL VISCOSITY CHART" in the
Main te nance section of this man u al).
•
To change engine oil, see the Main te nance section of
this manual.
Oil Level
Max Upper Level
Min Lower Level
9
Oil Filler Plug
FIG. 12
Publicité
Table des Matières
