ASROCK G43Twins-FullHD Mode D'emploi page 17

Table des Matières

Les langues disponibles

2.4 Expansion Slots (PCI and PCI Express Slots)

There are 2 PCI slots and 2 PCI Express slots on this motherboard.

PCI slots: PCI slots are used to install expansion cards that have the 32-bit PCI

interface.

PCIE slots:

PCIE1 (PCIE x1 slot; White) is used for PCI Express cards with x1 lane

width cards, such as Gigabit LAN card, SATA2 card, etc.

PCIE2 (PCIE x16 slot; Green) is used for PCI Express cards with x16

lane width graphics cards. If you want this motherboard to support

DVI-D and DisplayPort, please install ASRock DVI_DisplayPort Card on

this slot.

If you install the add-on PCI Express VGA card to PCIE2 (PCIE x16 slot),

the onboard VGA will be disabled. If you install the add-on PCI Express

VGA card to PCIE2 (PCIE x16 slot) and adjust the BIOS options "Primary

Graphics Adapter" to [Onboard] and "Share Memory" to [Auto], then the

onboard VGA will be enabled, and the primary screen will be onboard VGA.

Installing an expansion card

Step 1.

Before installing the expansion card, please make sure that the power

supply is switched off or the power cord is unplugged. Please read the

documentation of the expansion card and make necessary hardware

settings for the card before you start the installation.

Step 2.

Remove the bracket facing the slot that you intend to use. Keep the screws

for later use.

Step 3.

Align the card connector with the slot and press firmly until the card is

completely seated on the slot.

Step 4.

Fasten the card to the chassis with screws.

ASRock G43TwinsFullHD Motherboard

1 7

Table des Matières