Make Espresso Coffee - Sinbo SCM 2937 Mode D'emploi

MAKE ESPRESSO COFFEE

2. Then insert the funnel into the appliance from the
"Insert" position, and you can fix them into coffee maker
firmly through turn it anticlockwise until it is at the lock
position.(See fig. 1).
3. Pour out the hot water in the cup. Then place the hot
Fig. 1
cup (your cup) on removable shelf.
4. At the time, the ready indicator is illuminated, once the ready indicator is illuminated,
you should turn the coffee switch to the "—" position, waiting for a moment, there will
be coffee flowing out.
Note: During brewing coffee or making steam, it is normal that the ready indicator is
likely to extinguish, it only means that the heater is heating up to keep the temperature
at the standard range.
5. You should turn the ON/OFF switch to "O" position manually when desired coffee is
obtained or the colour of coffee changes weak obviously, the power indicator and ready
indicator go out and the coffee maker stops working, your coffee is ready now.
WARNING: Do not leave the coffee maker unattended during making the coffee, as you
need operate manually sometimes!
6. After finishing making the coffee, you can take the metal funnel out by turning it
clockwise, and then pour the coffee residue or the brewed coffee pod out with the mesh
pressed by press bar.
7. Let them cool down completely, then rinse under running water.
MAKE CAPPUCCINO
You get a cup of cappuccino when you top up a cup of espresso with frothing milk.
Note: during making steam, the metal funnel must be assembled in position.
Method:
1. Prepare espresso first with container big enough according to the part "MAKE ESPRESSO
COFFEE", make sure that the steam control knob is on the minimum position.
2. Turn the steam switch to the "—" position, waiting for until the ready indicator is
illuminated.
3. Fill a jug with about 100 grams of milk for each cappuccino to be prepared, you are
recommended to use whole milk at refrigerator temperature (not hot!).
Note: In choosing the size of jug, it is recommended the diameter is not less than 70±5mm,
and bear in mind that the milk increases in volume by 2 times, make sure the height of
jug is enough.
4. Insert the frothing device into the milk about two centimetres.
5. Turn the steam control knob slowly in anti-clockwise, steam will come out from the
frothing device. Froth milk in the way moving vessel round from up to down.
Note: Never turn the steam control knob rapidly, as the steam will accumulate rapidly
in short time which may increase the potential of the risk of explosion.
6. When the required purpose is reached, you can turn the steam control knob to the
minimum position.
Note: Clean steam outlet with wet sponge immediately after steam stops generating,
- 14 -