Before The First Use - Sinbo SCM 2937 Mode D'emploi

BEFORE THE FIRST USE

position.
Note: the appliance is not equipped with jug, please use yourself jug or coffee cup.
5. Connect to power source, turn the ON/OFF switch to the "—" position. The power
indicator will be illuminated.
6. Turn the coffee switch to the "—" position, the pump will pump water, when there is
water flowing out and turn the coffee switch to the "O" position, turn the steam switch
to the "O" position and waiting for a moment, the appliance begins to be pre-heated until
the ready indicator is illuminated, it shows the pre-heating is finished. Turn the coffee
switch to "I" position again, and water will flow out.
7. After water not dropping out any more, you can pour the water in each container out
then clean them thoroughly, now you can start brewing.
Note: There may be noise when pumping the water on the first time, it is normal, the
appliance is releasing the air in the appliance. After about 20s, the noise will disappear.
PRE-HEATING
To make a cup of good hot Espresso coffee, we recommend you preheating the appliance
before making coffee, including the funnel, filter and cup, so that the coffee flavour can
not be influenced by the cold parts.
Note: The appliance is equipped with two steel meshes of coffee powder mesh and coffee
pod mesh. Select desired steel mesh according to your desired.
1. Remove the detachable tank and open the tank cover to fill it with desired water, the
water level should not exceed the "MAX" mark in the tank. Then place the tank into the
appliance properly.
2. Set coffee powder mesh into metal funnel, then insert the funnel into the appliance
from the "Insert" position and release the press bar, and you can fix them into coffee
maker firmly through turn it anticlockwise until it is at the lock position.(See fig. 1).
3. Place an espresso cup (your cup) on removable shelf.
4. Then connect the appliance to power supply source. Make sure the steam control knob
is on the minimum position.
5. Turn the ON/OFF switch to the "—" position, the power indicator will be illuminated,
make sure the steam switch on the "O" position. Turn the coffee switch to the "—"
position, when there is water flowing out, turn the coffee switch to the "O" position
immediately. The purpose of the step is to pump the water of the tank into the housing.
6. When the ready indicator is illuminated, you should turn the coffee switch to the "—"
position again, there will be hot water flowing out. When the ready indicator is extinguished,
turn the coffee switch to the "O" position. The pre-heating is finished.
MAKE ESPRESSO COFFEE
1. Remove the metal funnel by turning it in clockwise, set coffee powder mesh into metal
funnel. Add ground coffee to the mesh with measuring spoon, a spoon ground coffee
power can make about a cup of top-grade coffee, then press the ground coffee powder
tightly with the tamper. If you use the coffee pod, you shall use the coffee pod mesh
instead of the coffee powder mesh.
- 13 -