Whirlpool AWG 1212/PRO Mode D'emploi page 41

Cleaning the Door Gasket
Open the washer door. Using both hands, press
down the door gasket. Remove any foreign objects
if found trapped inside the gasket. Make sure there
is nothing blocking the holes behind the gasket.
While holding down the door gasket, inspect the
interior gasket by pulling it down with your fingers.
Remove any foreign objects if found trapped inside
this gasket. Make sure there is nothing blocking the
holes behind the gasket.
When you are finished cleaning the door gasket,
remove your hands and the gasket will return to
the operating position.
Dispenser Drawer Area: Detergent and fabric
softener may build up in the dispenser drawer.
Residue should be removed once or twice a
month.
• Remove the drawer by first pulling it out until it
stops. Then reach back into the left or right rear
corner (depending on model) of the drawer
cavity and press down firmly on the lock tab,
pulling out the drawer.
• Remove the inserts from the bleach and fabric
softener compartments and the detergent insert.
Rinse the inserts and the drawer with hot water
to remove traces of accumulated laundry
products.
• To clean the drawer opening, use a small brush
to clean the recess. Remove all residue from the
upper and lower parts of the recess.
• Return inserts to the proper compartments.
Replace the dispenser drawer.
Tab on back right or left
depending on model
Lock tab is visible only after
drawer has been pulled open
41