Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The actual operating time may vary over time,
depending on the selected vibration mode and
speed level.
Charge the massager when the light rings
start flashing slowly to indicate that the battery is
almost empty.
1
Make sure that all parts (massager and charger)
are dry.
2
Insert the small plug into the charger and put
the adaptor in the wall socket.
3
Place the massager on the charger. It only fits
properly on the charger with the moulded
surface facing up and the buttons on the side.
The massager switches off automatically when you
place it on the charger.
, The massager slowly vibrates for a few seconds
to get into the correct position for optimal
charging.
Note: The charger does not work when the massager is
placed incorrectly on the charger.
, The charging light on the charger starts flashing
to indicate that the massager is being charged.
Note: When you charge the massager for the first
time or after a long period of non-use, it may take a
few minutes before the light rings start flashing. This is
normal.
Note: The appliance may produce a smell the first few
times you charge it. This is normal.
, When the battery is fully charged, the
light rings go out.
EnglisH
11
Publicité
Table des Matières
