To Inflate; After Use; Storage; Battery Disposal - Bontrager 407066 Manuel D'utilisation

• The Power Charger can get hot during use. After 15 minutes of use,
allow the Power Charger to cool.

to inflate

1. Attach the pump head to the product's
valve or to an inflation accessory.
2. Lock the pump head.
3. Press the On/Off/Battery Charge switch
to ON (Figure 5).
4. Watch the pressure gauge on the top of
Power Charger.
5. When the product is inflated, Press the
On/Off/Battery Charge switch to OFF.
the Power Charger can release air at high pressure. If the pump
head comes off during inflation, the pressure could make it move
uncontrollably, possibly strike you, and cause injury. If a product
is overinflated, it could explode, sending pieces at high velocity or
creating noise that could cause damage to your ears. Always lock
the pump head to the valve or inflation accessory prior to inflation,
and follow the inflation recommendations of the product.
After 15 minutes of use, allow the Power Charger to cool.

Storage

Store the Power Charger in a dry place
where the temperatures is between 65 and
75°F (18 and 24°C). Leave the lock of the
pump head in the Open position (Figure 6).
Make sure the On/Off/Battery Charge switch
is in the Off position.

Battery disposal

This Power Charger includes a lead-acid battery that is rechargeable
and sealed. The environmental laws in some countries require your
dealer to accept returns of rechargeable batteries for proper disposal.
Check the country laws before disposing of the battery.
the coated electrical wires of the Power Charger contain lead.
handling the wires exposes you to lead, a chemical known to the State
of California to cause cancer, birth defects, or other reproductive
harm. Always wash your hands after contact with the wires.
WArnInG
WArnInG
Figure 5. On/Off/Battery Charge
switch

After uSe

Figure 6. Lock lever of pump head
in Open position
Inflating 4