Dutch originals DO-CH-ACON120 Manuel D'utilisation page 14

on the digital control panel lights up.
Timer setting
The timer settings can be set from 1 hour to 24 hours.
There are 2 timer modes, to turn the device OFF and to turn it ON.
Timer turn OFF (when power is ON)
• Press the TIMER button on the device
digital control panel lights up 00.
• To set the timer delay OFF, press the increase
press the increase
or decreases by one hour. The selected time is indicated on the display
Timer turn ON (when power is OFF)
• Press the TIMER button on the device
the digital control panel lights up 00.
• To set the timer delay OFF, press the increase
press the increase
or decreases by one hour. The selected time is indicated on the display
Cancelling the set timer
To cancel the timer, press the increase
B
increase or decrease
Automatic defrost
At a low room temperature, frost may build up at the evaporator during operation.
The device automatically starts defrosting, the POWER LED
When the device is in cooling, smart (can be cooling in smart mode) or dehumidifying
mode, the ambient temperature sensor senses the evaporator coil temperature. When this
temperature is below -1°C, the compressor stops operating. Approximately 10 minutes
later, or when the coil temperature is ≥ 7°C, the device starts to cool again.
Overload protection
In the event of a power loss or cut, there is a 3-minute delay until the compressor restarts.
Self-evaporating system
The self-evaporating system uses the collected water to cool the condenser coils for a
more efficient performance. There is no need to empty the water tank in cooling operation.
The condensated water will be evacuated via the air exhaust
A
hose .
The device requires ventilation to the outside, so that the (hot) exhaust air and moisture
can be dispelled outside the room that is being cooled.
Drainage
For continuous or unattended operation, connect the drain hose
outlet of the device.
In this way condensate water can flow into a bucket or drain (by gravity).
B or decrease C
B or decrease C
C
button on the remote control, until OO shows on the display
or remote control
2
or decrease
6
button on the remote control. Each press increases
or remote control
2
or decrease
6
button on the remote control. Each press increases
or decrease
6
EN 12
D
until the display
button on the device or
7
8
D
until the the display
button on the device or
7
8
button on the device or press the
7
starts blinking.
1
and its connected exhaust
7
E
to the drain opening
on the
8
.
on
8
.
.
8
9