Before You Call For Service - Electrolux Icon E36GC76PRS Instructions D'installation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

GAS COOKTOP INSTALLATION INSTRUCTIONS

2. Turn on Electrical Power and Open Main

Gas Valve

3. Check the Igniters

Operation of electric igniters should be checked after

range and supply line connectors have been carefully

checked for leaks and range has been connected to

electric power.

a. To check for proper lighting, push in and turn a surface

burner knob to the LITE position. You will hear the

igniter sparking.

b. The surface burner should ignite when gas is available to

the burner. Purge air from supply lines by leaving knob

in the LITE position until burner ignites. Each burner

should light within four (4) seconds in normal operation

after air has been purged from supply lines.

c. Visually check that burner has a flame, Once the

burner ignites, the control knob should be turned out

of the LITE position.

d. Try each surface control knob separately until all

burner valves have been checked. Each burner

location is equipped with a separate electrode.

4. Adjust the "LOW" Setting of Surface Burner Valves

(linear flow)

Test to verify if LOW setting should be adjusted:

a. Push in and turn control to LITE until burner ignites.

b. Push in and quickly turn knob to lowest position.

c. If burner goes out, reset control to OFF.

d. Remove the surface burner control knob.

e. Insert a thin-bladed screwdriver into the hollow valve

stem and engage the slotted screw inside. Flame size

can be increased or decreased with the turn of screw.

Turn counterclockwise to increase flame size. Turn

clockwise to decrease flame size (Figure 13).

Adjust flame until you can quickly turn knob from

LITE to lowest position without extinguishing the

flame. Flame should be as small as possible without

extinguishing.

Hollow

Valve

Stem

Figure 13

When All Hookups are Complete

Shutoff

Make sure all controls are left in the OFF position.