Hobbytech SPIRIT EVO RTR Manuel D'instruction page 5

even if THiS CAR iS A ReAdy To Run kiT, you STiLL HAve SoMe LiTTLe THinGS To do To fAMiLiARize WiTH
youR PRoduCT. PLeASe foLLoW THeSe STePS.
install tHe Batteries to tHe transmitter
A
- Remove the battery cover from the transmitter by sliding it in the direction of the arrow in the figure
- Remove used batteries.
- Load new AA size batteries. Pay very close attention to polarity markings and reinsert accordingly (
- Slide the battery cover back onto the case.
install tHe receiVer BatterY
A
C
Bind
A
Place model on a block to prevent wheels from touching the ground.
Turn on transmitter switch and the LED battery indicator will light up. If it blinks or doesn't light up, check polarities and battery power.
A
Turn ON receiver switch.
B
You must check the signal of transmitter and receiver before you operating it at first. Make sure TH Trim is on neutral, TH D/R is on maximum
value (10), and ST in on NOR. With a tip, push on SWITCH receiver button during 3 seconds, then release : Red LED blinks, then lights. This
means your transmitter is correctly synchronized with your receiver.
B
B
.
C
).
B
A
Remove the 2pcs receiver box clips from the cover of the
receiver box.
B
Install 4pcs, AAA sizes battery (not provided) and secure
the hole set with some tape (more secure)
C
Install the battery case in the receiver box properly and
connect the red plug.
You can close the receiver box cover.
B
C
5