Unpacking And Assembly - Dyna-Glo Delux SF70DGD Guide D'utilisation Et Instructions De Fonctionnement

NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!

3. UNPACKING AND ASSEMBLY

1. UNPACKING
REMOVE THE HEATER AND ALL PACKING
MATERIALS FROM THE BOX.( Fig. 2 )
NOTE : Save the shipping carton and packing materials
for future storage.
2. ASSEMBLY
Tools Required
• Medium Phillips Screw driver.
1. Remove the pre-assembled Bolts on the shell
and shell ring.
2. Align the holes in the shell with two mounting
holes on the handle as shown in Figure3.
3. Secure handle with Bolts.
4. Align the holes in the shell ring with two
mounting holes on the heat shield as shown in
Figure 3.
5. Secure heat shield with Bolts.
CAUTION : DO NOT operate heater without heat shield assembled to the heater.
The heat shield must attached to prevent any damage, discoloration, or deformation to the floor.
NOTE : Heater should be inspected before each use, and at least annually by a qualified service person.
Handle
Figure 2. Packing Materials
Shell
Shell Ring
Heat Shield
Bolt
Figure 3. Assembling Handle, Heat Shield
3
Heat Shield
Bolt
Handle
Remove Bolts
Remove Bolts