Cleaning And Care - Clatronic HTD 2690 Profi Mode D'emploi

4....-05-HTD 2690 Profi
4. Setting the Temperature Level (right switch):
Position 1:
Position 2:
Position 3:
Setting the desired blower strength (left switch):
Position 0: OFF
Position 1: gentle stream of air
Position 2: strong stream of air
COOL-Shot:
TURBO button: By pressing the turbo button you can increase the air current
Clean the air suction opening from time to time with a fine brush. Clean the hou-
sing with a soft, dry cloth without additives.
Removing the air suction cover
Remove the cover after turning the cap through approximately 30 degrees against
a clockwise direction. Remove the intake filter and clean under running water. Dry
the filter well before mounting again!
This device has been tested according to all relevant current CE guidelines,
such as electromagnetic compatibility and low voltage directives, and has been
constructed in accordance with the latest safety regulations.
Subject to technical changes without prior notice!
The device supplied by our Company is covered by a 24 month guarantee starting
on the date of purchase (receipt).
During the life of the guarantee any fault of the device or its accessories *) ascriba-
ble to material or manufacturing defects will be eliminated free of charge by repai-
ring or, at our discretion, by replacing it. The guarantee services do not entail an
extension of the life of the guarantee nor do they give rise to any right to a new
guarantee!
Proof of the guarantee is provided by the proof of purchase. Without proof of
purchase no free replacement or repair will be carried out.
30.01.2002 16:34 Uhr
cold air
medium temperature for gentle drying and shaping
high temperature for rapid drying
With this switch it is possible to interrupt the heating
process so that the air can be mixed according to individual
requirements.
even further.

Cleaning and care

Guarantee
Seite 21
GB
21