Emergency Procedures; Electric Shock; Troubleshooting Guide - BriskHeat GBH0250-1 Manuel D'instructions

EMERGENCY PROCEDURES

Read and understand these procedures prior to using this heater. Disconnect
power to the heater in the event of an emergency.

Electric Shock:


Do not touch the injured person while they are still in contact with the electrical current.

Call your local emergency service if the injured person experiences: severe burns, confusion, difficulty
breathing, heart rhythm problems, cardiac arrest, muscle pain and contractions, seizures or a loss of
consciousness.
Minor Burns:

Hold the burned area under cool running water for 10-15 minutes.

Remove rings or other tight items from burned area.
Major Burns:

Call your local emergency service.

Protect the person from further harm.

Remove rings or other tight items from burned area.

Monitor breathing and perform CPR if necessary.
Fire:

Call your local emergency service.

If it is safe to do so, use a fire extinguisher to fight the fire, otherwise evacuate to a safe distance and wait
for help to arrive.

This heater is built from material that will not support a flame but could ignite nearby combustible material.
®
© BriskHeat Corporation. All rights reserved.
Silicone Rubber Beaker Heater
7

TROUBLESHOOTING GUIDE

Please read this guide prior to contacting BriskHeat
commonly asked questions. If you are unable to identify the problem or need additional
assistance, please contact your local distributor/ representative or us at
1-800-848-7673, 614-294-3376, or bhtsales1@briskheat.com.
PROBLEM
Does not heat Verify heater is connected to proper voltage.
Check to see if there is a resistance reading (not an open circuit) in
heater using an ohm meter.
Circuit breaker is Validate that the circuit breaker is capable of handling the amp
tripping requirement of heater. The identification label located on the power
cord displays the heater's amperage requirement.
Examine heater and cord for any damage.
Check to see if there is a resistance reading between power leads.
Does not fit Designed for only specific sized glass beakers. Check to be sure the
beaker size and heater size match.
®
© BriskHeat Corporation. All rights reserved.
Silicone Rubber Beaker Heater
®
. This guide is designed to answer the most
SOLUTION(S)
8