Listening To Stored Stations - Aiwa RMD-77 Mode D'emploi

14
en
USING THE STORED STATIONS
MW/LW ATS :
Press the MW/LW button to select MW/LW band, then follow step 2 of FM ATS.
SW ATS :
Fully extend the telescopic antenna and press the SW ( ) or ( ) buttons to
select SW band.
Modes for SW ATS tuning
A.
Using all the meter bands:
Press and hold the ( ) button to ATS the stations within all meter bands.
B.
Using the present meter band:
Press and hold the ( ) button to ATS the stations within the present meter band.
Notes:
• During ATS process in FM, MW / LW or SW (mode A), pre-stored radio stations will
be replaced automatically by the new searched stations.
• With ATS in SW (mode B), those existing memories will not be replaced; all the
newly found radio stations will be stored in the blank memory addresses.
• If there is too much interference in your surrounding or many mirror/blank stations
are being stored during ATS, you should contract the telescopic antenna (FM and
SW) or rotate the radio for better reception (MW and LW).
METHOD 2: STORING STATIONS MANUALLY
Select band and tune to your desired station.
1.
2. Press the M button with the word "PRESET " flashing.
3. Press the M button again to store the station into memory.
Note that you can also wait for 3 seconds to auto store the station into memory.
METHOD 3: SEMI-AUTO STORING STATIONS
While operating the Auto Browse Station function, you can simply press on the M
button to store the station into memory to avoid storing unwanted stations and
interfering signals.
1. Press the VM/VF button to switch into frequency mode.
Press and hold the VM/VF button until "
2.
browse from one station to another.
3. While tuning to your desired station, press the M button followed by "PRESET "
flashing to directly store the station into the next available memory.
The unit will keep on browsing until you deactivate it by pressing on the VM/VF
button again.
" advancing on the screen to auto

LISTENING TO STORED STATIONS

METHOD 1: MANUAL MEMORY TUNING
Press the VM/VF button to enter
the memory mode, the word
"PRESET " will appear on the
screen. Then rotate the TUNING
KNOB to scroll through the stored
stations one by one.
METHOD 2: AUTO BROWSE MEMORY
Press the VM/VF button
1.
followed by "memory page"
that appears in the upper
right corner to enter the
memory mode.
Press and hold the VM/VF
2.
button until "PRESET " flashes
to automatically scan from
one memory to another,
remaining on each station
for approximately 5 seconds.
To stop the automatic search
memory, simply press the
VM/VF button.
METHOD 3: DIRECT KEY IN MEMORY ADDRESS
Press the VM/VF button to enter the memory mode.
1.
2. Press the numeric keys 0-9 to enter the memory address directly, and then
press the button ( ) to confirm.
The auto scan function will store all the available stations in the ETM memory.
Note:
• If the display shows " - - - - " symbol after entering the number, it means that the
entered memory address does not exist.
15