Display Mode; System Settings; Snooze Function - Aiwa RMD-77 Mode D'emploi

18
en
ALARM
SETTING THE ALARM BY RADIO
Alarm by radio station:
1. Turn on the radio, then tune into your favorite station for alarm by radio and
adjust your desired alarm volume level.
2. Press the button M button with "PRESET " flashing.
3. Press the ALARM button immediately and the "
display to confirm the preset alarm station.
Note:
• The radio will turn on automatically playing the preset station when it reaches
the alarm time. It will auto turn off as well when it reaches the preset alarm off
timer.
TURNING THE ALARM ON OR OFF
You can press the ALARM button repeatedly to activate/deactivate the alarm by
buzzer / radio respectively.
If " " shows on the display, it means the alarm by buzzer is turned on.
If " " shows on the display, it means the alarm by radio is turned on.
If " " / " " does not show on the display, it means the alarm by buzzer / radio is
turned off.
SWITCH OFF THE ALARM
Buzzer alarm:
Press the POWER button to turn off the alarm.
Radio alarm:
Press the POWER button to continue listening to the radio, press twice to
turn off the station alarm.
Note:
• If the preset alarm is activated when you are listening to the radio, it will auto
switch to the preset radio station.

SNOOZE FUNCTION

When the preset alarm is activated, you can press the LIGHT/SNOOZE button to
temporarily turn off the alarm, the alarm will sound again 5 minutes later.

DISPLAY MODE

" symbol will appear on the

SYSTEM SETTINGS

INTELLIGENT LIGHT FUNCTION
This radio has an intelligent lighting function with which the backlight would be on for
5 seconds when operating any keys or knobs.
You can use the following methods to turn on/off the backlight:
Note:
•
•
With radio OFF:
Press repeatedly the
DISPLAY button to view
temperature or alarm
time.
With radio ON:
Press repeatedly the
DISPLAY button to view
local time, alarm time,
temperature or signal
strength showing on the
upper right corner of the
display.
A.
Temporary illumination:
Press the LIGHT/SNOOZE button with a "Beep" sound to illuminate the LCD for
5 seconds.
B.
Permanent illumination:
Press and hold the LIGHT/SNOOZE button until a prolonged double beep
"Beep" sound heard for permanently illumination.
Press it again with a double beep sound to turn off the backlight.
When the unit is powered by the batteries, please try to avoid setting the backlight
to permanent illumination to reduce power consumption.
When the unit is turned off, the permanent illumination function will be turned
off automatically as well.
POWER
DISPLAY
LIGHT/ SNOOZ E
12/24 9/10kHz
2 3 FM
19