Aiwa RMD-77 Mode D'emploi page 7

12
en
TUNE INTO STATIONS
TIPS TO IMPROVE RECEPTION
A.
For FM stations:
When you are in a different city or country, you should perform the ETM function again
instead of using ATS function, because this will not delete any of the stations already
stored within the memory.
B. For MW stations:
We highly recommend to perform the ETM function again during night time, as many
stations start broadcasting at night.
C.
For SW stations:
It is recommendable to perform the ETM function in the morning, afternoon as well as
night time, because the transmitting signal of SW is very unstable and usually there are
more stations that start broadcasting in the late afternoon.
Note:
• While operating ETM to search for stations, a few stations might be missed if there
is interference in the surrounding. In this case, you can simply key-in the frequency,
then press the ETM button to manually store it into the ETM memory.
METHOD 2: MANUAL TUNING
A.
Frequency searching:
Press the VF/VM button to switch
into frequency mode, and then
rotate the TUNING KNOB knob to
select your desired station.
B.
Memory searching:
Press the VM/VF button to switch into memory mode, "VM" will appear on screen.
Then rotate the TUNING KNOB to select those stored stations.
METHOD 3: AUTO BROWSE STATIONS
Turn on the radio and press
1.
the VM/VF button to switch
into frequency mode.
Press and hold the VM/VF
2.
button until the FAST TUNING
speed mode " " starts
scanning from one station
to another, staying on each
station for about 5 seconds.
To stop the auto browse
3.
function, simply press the
VM/VF button again.
Note:
• While operating the Auto-browse Station function, you can press the M button
anytime to store the current station into memory; the unit will keep on auto
browsing the next available station afterwards.
TUNE INTO STATIONS
METHOD 4: DIRECT KEYPAD ENTRY
To search for a frequency, turn on the radio and press the VM/VF button to switch into
frequency mode, press the numeric keys 0-9 to enter the station frequency directly.
To search for those stored stations, press the VM/VM button to switch into memory
mode, then press the numeric keys 0-9 to enter the preset memory number directly.
Notes:
• Ignore the decimal point for FM band when inputting the frequency numbers.
For example, FM 89.3 MHz, just enter 8 9 3.
• If the entered frequency is not within the covering area,the display would display
"Err" (error) symbol.
USING THE STORED STATIONS
There's a total of 550 preset memories within the unit. 100 preset memories for each
FM, MW, and LW band, and 250 for SW.
METHOD 1: ATS (AUTO TUNING STORAGE)
1. Fully extend the telescopic
antenna and then press the
FM button to select FM band.
Press and hold the FM button,
2.
until the word "PRESET "
appears flashing on screen
on screen and the frequency
starts advancing; now the
radio will start scanning and
storing all the avalible radio
stations into the memory.
When the frequency stops, it
means that the ATS operation
is already done. Then you can
rotate the TUNING KNOB to
search for those stored stations.
13