Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SHORTCUT function
Press SHORTCUT button (some units). Push this button when remote controller is on,
the system will automatically revert back to the previous settings including operating
mode, setting temperature, fan speed level and sleep feature (if activated).
If pushing more than 2 seconds, the system will automatically restore the
current operation settings including operating mode, setting temperature,
fan speed level and sleep feature (if activated ).
CLEAN-Function
Press CLEAN button. Airborne bacteria can grow in the moisture that condenses around
heat exchanger in the unit. With regular use, most of this moisture is evaporated from
the unit. By pressing the CLEAN button, your unit will clean itself automatically. After
cleaning, the unit will turn off automatically. Pressing the CLEAN button mid-cycle will
cancel the operation and turn off the unit. You can use CLEAN as often as you like.
Note: You can only activate this function in COOL or DRY mode.
TURBO function
Press turbo button. When you select turbo feature in COOL mode,
the unit will blow cool air with strongest wind setting to jump-start the cooling process.
When you select turbo feature in HEAT mode, for units with Electric heat elements,
the Electric HEATER will activate and jump-start the heating process.
SET function
Press the SET button to enter the function setting, then press SET button or TEMP ▲ or ▼ button to
•
select the desired function. The selected symbol will flash on the display area, press the OK button to
confirm.
•
To cancel the selected function, just perform the same procedures as above.
•
Press the SET button to scroll through operation functions as follows: Fresh (
Me(
) AP mode(
button to select the Fresh and Sleep feature.
FRESH FUNCTION
When the FRESH function is initiated, the ion generator is energized and will help to purify the air in the
room.
SLEEP FUNCTION
The SLEEP function is used to decrease energy use while you sleep (and don't need the same tempera-
ture settings to stay comfortable). This function can only be activated via remote control.
NOTE: The SLEEP function is not available in FAN or DRY mode.
4
30
Remote-man_RG10 EU ('21) V2.indd 30
Remote-man_RG10 EU ('21) V2.indd 30
): If your remote controller has Fresh and Sleep button, you can not use the SET
(SOME UNITS):
:
) Sleep (
) Follow
16-11-2021 17:15
16-11-2021 17:15
Publicité
Table des Matières
