Troubleshooting - Smartpond 71141 Mode D'emploi

Use a soft cloth or brush
and warm water to clean the
impeller and the inside of the
impeller housing.
Step 7. Remove the nozzle
and clean with warm water.
Step 8. Remove the light ring
by turning counterclockwise
and clean with warm water.
Step 9. Reassembly all
parts making sure to fasten
all interior electrical cords
safely. Place the fountain
into the water, and connect
the fountain into a properly
grounded electrical outlet.

TROUBLESHOOTING

IF THE LED LIGHTS FAIL TO OPERATE:
• Check to make sure the power cord is plugged in and the lights are
getting power and the unit is getting power.
• Check to make sure you have turned on the lights using the remote.
• Check to make sure the Dawn to Dusk Sensor is covered if you would
like the lights to operate during the day.
IF THE REMOTE FAILS TO CONTROL THE LIGHT:
• Check to make sure the plastic tab has been removed from the remote.
• The remote sensor will time-out during periods of inactivity. If your
selection is not being read, simply press the "strobe" and "fade" buttons
simultaneously before making your next section.
• Make sure to replace the 1 CR2025 battery every 6 months.
• Make sure the remote is within range of the fountain.
IF THE PUMP FAILS TO OPERATE:
• Check to make sure the power cord is plugged in, the pump is getting
power.
• Remove the impeller cover to expose the impeller. Turn the impeller to
ensure that it is not broken or jammed.
PLEASE CALL CUSTOMER CARE BEFORE RETURNING ITEM TO LOWE'S: 1-888-755-4497
7
Zip tie release
button
8
5
6
9
5