Assembly Instructions - MTD Yard Machines MCT333707 Manuel De L'utilisateur

INSTALL / ADJUST THE HANDLE
1. Install the middle clamp housing on the shaft near
the arrows on the sticker (warning label).
2. Put the lower clamp over the shaft and tighten the 2
screws.
3. Install the J handle on the middle clamp housing,
then put the upper clamp over the J-handle and
tighten the other 2 screws.
Upper
Clamp
Shaft
Middle
Clamp
Lower
Clamp
INSTALL THE CUTTING ATTACHMENT SHIELD
NOTE: The cutting attachment shield must be installed
to properly dispense the trimming line.
To install the cutting attachment shield:
1. Place the cutting attachment shield onto the shaft
bracket (Fig. 2).

ASSEMBLY INSTRUCTIONS

Screws
Handle
Fig. 1
WARNING:
cutting attachment shield in place to pre-
vent serious personal injury.
Cutting Attachment
Shield
2. Insert the bolt through the shield, bracket, washer
and lock washer tighten with the wing nut (Fig. 3).
Never operate the
trimmer without the
Bracket
Fig. 2
Wing Nut
Lock Washer
Washer
Bolt
Fig. 3
7