Binzel Abicor iSTM Mode D'emploi page 35

iSTM
NOTICE
Press the corrugated hose of the cable assembly (5) into the webs of the clamp (6) and turn
the corrugated hose by hand until it rotates in the clamp (6).
8 Insert the corrugated hose of the cable assembly (5) into the clamp (6) and clamp it using
the cylinder screws (7).
6.3 Attaching the ABIROB
1
1 ABIROB
2 Allen key
Fig. 7
1 Equip the ABIROB
2 Insert the ABIROB
3 Tighten the set screws (5) using an Allen key (2). Tightening torque M= 2.5 Nm.
4 Close the lock ring (3) by rotating it to the left.
NOTICE
• The welding torch is equipped with a contact tip for a wire diameter of 1 mm and a gas
nozzle NW16. If you need a different equipment, please order it separately.
 appendix
BAL.0150 • 2020-08-03
®
A torch neck
2
®
A torch neck 3 Lock ring
4 iSTM fastener
Attaching the ABIROB
®
A torch neck (1) with a tip adaptor, contact tip and gas nozzle.
®
A torch neck (1) via the guide grooves until the stop into the iSTM (4).
3 4
®
A torch neck
6 Putting into operation
5
5 2 set screws
EN - 13