Télécharger Imprimer la page

koban KDT-1000 Manuel Du Propriétaire page 8

Publicité

Les langues disponibles

Les langues disponibles

0767531
Low battery indication:
Scenario 1 – Powering on the tester: The "power on" LED in the tip of the tester
changes from a steady green to a blinking green and a series of beeping sounds is
generated. The tester then turns off. The unit is now deactivated and is not operational;
the batteries require replacement. To replace the tester batteries refer to the
Maintenance section titled "Battery Replacement."
Scenario 2 – Operating the tester: If the LED lights dim and the tone fades, the tester
may require new batteries. To replace the tester batteries refer to the Maintenance
section titled "Battery Replacement."
Auto Power Off:
After 5 minutes of non-use, the tester automatically powers off to conserve battery life.
Listen for a double-beep sound and watch the "power on" green LED turn off. The
tester is now deactivated and is not operational.
Flashlight Operating
Press and hold the Flashlight ON/OFF button to turn on Flashlight.
Battery Replacement:
1. Remove the end cap by gently lifting the pocket clip to release the catch.
2. Insert two AAA batteries (observe polarity).
3. Replace the end cap
NOTE: If your meter does not work properly, check the battery to make sure that it
still good and that it is properly inserted.
Specifications:
Voltage range: 50 V ac to 1000 V ac
Tester type: Non-Contact Voltage Detector
Voltage detection indicators:
Visual : Hight intensity Red LED
Audible: Discontinuous Beeping Sound
Operating conditions:
Temperature: 32° to 104° F (0° to 40° C)
Relative Humidity: <80%
Altitude: Up to 6,562 feet (2,000 meters) maximum
Environment: Indoor Use
Storage conditions:
www.grupotemper.com
Non-Contact AC Voltage Tester +Flashlight
Temperature: 32° to 104° F (0° to 40° C)
Relative Humidity: <80%
Altitude: Up to 6,562 feet (2,000 meters) maximum
Environment: Indoor
Power on indicator & illuminator :
Visual: High Intensity Green LED
Power off & auto power off:
Visual: Power-On LED turns off
Audible: Double Beeping Sound
Low battery indicators:
Visual: Green LED Blinks
Audible: Series of Beeping Sounds
Batteries: Two " AAA"1.5V betteries
Pollution degree: 2
Safety Complies with EN 61010-1 2nd Edition, EN 61326 EMC CATIII 1000V
KDT-1000
2

Publicité

loading