Publicité
Les langues disponibles
Les langues disponibles
KDT-1000
Non-Contact AC Voltage Tester +Flashlight
Non-Contact AC Voltage Tester +Flashlight
Owner's Manua
Read First: Safety Information
Warnings:
• It is important that users of this tester read, understand, and follow all warnings,
cautions, safety information, and instructions in this manual before operating or
servicing this tester. Failure to follow instructions could result in death or serious
injury.
• Risk of electric shock and burn. Contact with live circuits could result in death or
serious injury.
• Use caution with voltages above 30V AC as a shock hazard may exist.
• A steady red glow and continuous beep indicates voltage present. If no indication,
voltage could still be present.
• In bright light conditions, the LED visual indicators will be less visible.
• Do not use if green LED is not illuminated.
• Do not use if tester appears damaged or if the tester is not operating properly. If in
doubt, replace the tester.
• Do not apply more than the rated voltage as marked on the tester (1000 Volts AC).
• Always wear approved eye protection.
• Before each use, verify operation by testing a known working circuit that is within
the rating of this tester.
• Do not rely on this tester with shielded wire. Operation may be affected by
differences in socket design and insulation thickness and type.
• Comply with local and national safety requirements.
• If this tester is used in a manner not specified by the manufacturer, protection
provided by the tester may be affected.
1
Caution:
• Do not attempt to repair this tester. It contains no serviceable parts.
• Do not expose the product to extremes in temperature or high humidity.
Symbols:
- Double Insulated.
Caution. Risk of electric shock.
Risk of danger. Important information. See Manual.
CATIII 1000V - Equipment is designed to protect against transients from the
primarysupply level.
Operating Instructions:
Turn unit on:
Press the power button for 1 second. Listen for single-beep sound and watch for a
steady green LED to illuminate and red LED to illuminate 0.5S turn off in the tip of
the tester. Release the power button; the tester is now activated and is operational. Test
on known live circuit to verify tester functionality.
Turn unit off:
Press and hold the power button for 2 second. Listen for a continuous sound and watch
the "power on" green/red LEDs turn off. Release the power button; the tester is now
deactivated and is not operational.
System self-test:
The "power on" green/red LED & Beeper visually confirms battery sufficiency,
system integrity, and operation/active mode. Always test on known live circuit to
verify tester functionality prior to use.
Checking for the presence of AC voltage:
Prior to use, test on known live circuit to verify tester functionality.
Place tip of the tester near an AC voltage. If the tester detects voltage, the "power on"
LED in the tip of the tester changes color from green to red and a discontinual beeping
sound is generated.
0767531
www.grupotemper.com
Publicité
