URBANGLIDE Ride-61+ Mode D'emploi page 6

Unfold the product
1. Pull up the red tube.
2. Rise the tube to the top.
3. Continue unfolding the scooter until the folding hook reaches and locks into the
slots.
Charge the product
1. Make sure the charging connector is clean and dry.
2. Start by plugging the switch into the power interface, and then plug the other
end of the charger into the product.
3. When the red indicator lights up on the charger, it means charging is
successful, if not, check all cable connections.
4. When the LED on the charger changes from red to green, the battery is fully
charged. Stop loading. Charging time that is too long may affect the life of the
battery.
Use the product
Position yourself on the basis of the product, give a slight pulse forward and
press the accelerator in order to initiate the engine.
Press harder on the accelerator to increase the speed.
Press the engine brake to slow down or press the rear wheel to brake manually.
6