Reset Scaling; Zoom/Crop Image; Map; Offset Settings - Chauvet Professional VIP DRIVE 43s Manuel De L'utilisateur

Reset Scaling

To reset the scaling settings to default:
1. Access the Scale
2. Turn the <SCROLL/ENTER> knob until Scale is selected.
3. Press the <SCROLL/ENTER> knob.
4. Turn the <SCROLL/ENTER> knob until Reset is selected.
5. Press the <SCROLL/ENTER> knob.

Zoom/Crop Image

The Zoom/Crop Image menu provides the zoom functions for cropping the video output.
To access the Zoom/Crop Image menu:
1. Access the Scale
2. Turn the <SCROLL/ENTER> knob until Advanced is selected.
3. Press the <SCROLL/ENTER> knob.
4. Turn the <SCROLL/ENTER> knob until Zoom/Crop Image is selected.
5. Press the <SCROLL/ENTER> knob.
There are 7 different zoom values that can be set to precision. Each one stretches the video output in 1, 2,
or 4 directions.
1. Access the Zoom/Crop Image
2. Turn the <SCROLL/ENTER> knob to select from Top (1), Bottom (1), Top/Bottom (2), Left (1),
Right (1), Left/Right (2), or Center (4).
3. Press the <SCROLL/ENTER> knob.
4. Turn the <SCROLL/ENTER> knob clockwise or counterclockwise to increase or decrease the
zoom, from 0–_ _ _ _ (The maximum values are determined by the scale and the other zoom
values. Editing these values may cause changes to the other zoom values).
5. Press the <SCROLL/ENTER> knob.
6. Repeat steps 2-5 until the zoom is set as desired.
Reset Zoom
To reset the zoom values to 0:
1. Access the Zoom/Crop Image
2. Turn the <SCROLL/ENTER> knob to select Reset.
3. Press the <SCROLL/ENTER> knob.

Map

The Map settings define the arrangement and number of panels for each port, and well as semi-global and
individual offsets.
To access the Map menu, press <MAP> (if it is set to default) or:
1. Press <MENU> to access the menu.
2. Turn the <SCROLL/ENTER> knob until Map is selected.
3. Press the <SCROLL/ENTER> knob.

Offset Settings

The Offset Settings determine the semi-global positions of ports 1 and 2 together and ports 2 and 3
together on the connected panel assembly.
1. Access the Map
2. Turn the <SCROLL/ENTER> knob to select Offset Settings.
3. Press the <SCROLL/ENTER> knob.
4. Turn the <SCROLL/ENTER> knob clockwise or counterclockwise to select from Port 1/2 Offset
X (ports 1 and 2 horizontal position), Port 1/2 Offset Y (ports 1 and 2 vertical position), Port 3/4
Offset X (ports 3 and 4 horizontal position), or Port 3/4 Offset Y (ports 3 and 4 vertical position).
5. Press the <SCROLL/ENTER> knob.
6. Turn the <SCROLL/ENTER> knob clockwise or counterclockwise to increase or decrease the
value, from 0–65535.
7. Press the <SCROLL/ENTER> knob.
8. Repeat steps 4-7 until the offsets are set as desired.
29
menu.
menu.
menu.
menu.
menu.
O
PERATION
VIP Drive 43s User Manual Rev. 1