Glen Dimplex SoftHeat Serie Manuel D'utilisation page 4

OPERATING INSTRUCTIONS
Make sure all wires are properly connected and installation is complete
before you turn on the heater.
How to operate your heater
The room temperature is controlled by the thermostat on the heater. Once installation is complete
and power has been restored, follow the steps below for your thermostat:
1. Turn the thermostat knob all the way to the right.
2. When the room reaches your comfort level, turn the knob to the left, just until it clicks and the
heater turns off. The heater will automatically keep the room temperature around this setting.
3. To reduce the room temperature, turn the knob to the left. To increase the room temperature, turn
the knob to the right.
All wiring connections inside wiring compartment
L1
Red
Black
L2
Red
Black
Ground
Wiring Diagram for use with
All wiring connections inside wiring compartment
Red
L1
Black
Red
Black
Black
White (120V) or Orange (208V)
Neutral
Ground
One hot, one neutral supply wire
For more effective and safer operation and to prolong the
life of the heater, read the Owner's Guide and follow the
instructions. Failure to properly maintain the heater will
void any warranty and may cause the heater to function
improperly.
LIMITED ONE YEAR
will repair or replace any hydronic baseboard EBKN
thermostat found to be defective within one year after the
date of purchase.
These warranties do not apply:
1. Damage occurs to the product through improper
installation or incorrect supply voltage;
2. Damage occurs to the product through improper
maintenance, misuse, abuse, accident, or alteration;
3. The use of unauthorized accessories or unauthorized
components constitutes an alteration and voids all
warranties. Refer to Manufacturer website or call
To register your product, visit gdaheat.com/register
More frequently asked questions on our website here: gdaheat.com/FAQ
Reduce-Reuse-Recycle
This product is made primarily of recyclable materials. You can reduce your carbon footprint by recycling
this product at the end of its useful life. Contact your local recycling support center for further recycling
instructions.
©2020 Glen Dimplex Americas
INTERNAL HEATER WIRING DIAGRAMS
All wiring connections inside wiring compartment
Black
Figure 3
240 and 208 volt heater
Two hot supply wires
120 volt only
Figure 5
Wiring Diagram for use with
120 and 208 volt heater
WARRANTY:
Manufacturer
Printed in USA
4
Figure 2
Wiring Diagram for use with
240 and 208 volt heater
Two hot supply wires
All wiring connections inside wiring compartment
Figure 4
Wiring Diagram for use with
120 and 208 volt heater
One hot, one neutral supply wire
All wiring connections inside wiring compartment
120 volt only
WARRANTY
customer service at 888.346.7539 for list of authorized
accessories and components.
4. Manufacturer's warranty is limited to repair or
replacement.
5. In the event Manufacturer elects to replace any part
of your product, the replacement parts are subject to
the same warranties as the product. The installation of
replacement parts does not modify or extend the under-
lying warranties. Replacement or repair of any product or
part does not create any new warranties.
If you believe your product is defective, please contact
Manufacturer during the warranty period, for instructions
on how to have the repair or replacement processed.
Parts and Service
Visit gdaheat.com/parts for information on where to
obtain parts and service.
Black Black Red
L1
Black Black Red
L2
Ground
Black
with
label
Neutral
Black
Red
L1
Black
Red
Black
Ground
Rev 08/20/20 #706982