Operation; Preparation; Adjusting The Harness - Senix CSPE6.5-M Manuel D'instructions

WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
WARNING:
Motor housing can become hot during pole saw
operation. Do not rest or place your arm, hand, or any
body part against the motor housing. Extended contact
with the motor housing can result in burns or other
injuries.
WARNING:
Always position the unit on the operator's right side. The
use of the unit on the operator's left side will expose
the user to hot surfaces and can result in possible burn
injury. To avoid burns from hot surfaces, never operate
unit with the bottom of the motor above waist level.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
WARNING:
Operation of this equipment could create sparks that
can start fires around dry vegetation. The operator
should contact local fire agencies for laws or regulations
relating to fire prevention requirements.
WARNING:
Operate this unit only in a well-ventilated outdoor area.
CAUTION:
Do not overwork yourself. Take regular breaks and
change working position to ensure you can concentrate
on the work and have full control over the product.
Maintain firm footing and balance during operation.
CAUTION:
Inspect unit before each use. Replace damaged parts.
Check for fuel leaks. Make sure all fasteners are in
place and secure.
WWW.SENIXTOOLS.COM

OPERATION

PREPARATION

Before each use, check the following items to ensure
safe working conditions.
POLE SAW: Before beginning work, inspect the pole
saw for damage to the housing, the saw chain and the
guide bar. Never use a damaged machine.
OIL TANK: Check the fill level of the oil tank. Also check
whether there is sufficient oil available while working.
Never operate the saw if there is no oil or the oil level is
not visible in order to prevent damage to the pole saw.
SAW CHAIN: Check the tension of the saw and the
condition of the blades. The sharper the saw chain is,
the easier and more manageable operations will be.
The same applies to chain tension.
Check the tension every 10 minutes of operation
to maximize safety. New saw chains in particular
are subject to changes due to the heat created by
operation.
PROTECTIVE CLOTHING: make sure to wear the
appropriate close- fitting protective clothing such as
hainsaw-protective pants, gloves and safety shoes.
Wear a safety helmet with integrated hearing protection
and a face guard to provide protection against falling
and recoiling branches.
ADJUSTING THE TELESCOPING HANDLE
Telescoping
Release
Lever
1. Unlock the telescope release lever so that the pole
can freely extend outwards and inwards.
2. Extend it to the desired length and lock the telescope
release lever to hold it in place.

ADJUSTING THE HARNESS

Adjust the harness to a length which is suitable for your
operation.
Always use the harness to carry the product weight on
your shoulder (on the same side of tool or cross your
body). Ensure that the quick release is on your chest
(NOT on your back).
Short
Long
11